New User Manuals
www.cda.eu FF770 Freestanding Frost Free Fridge Freezer Installation, Use and Maintenance
2 Important The CDA Group Ltd cannot be held responsible for injuries or losses caused by incorrect use or installation of this product. Please note that CDA reserve the right to invalidate the guarantee supplied with this product following incorrect installation or misuse of the appliance. This appliance is not designed to be used by people (including children) with reduced physical, sensorial or mental capacity, or who lack experience or knowledge about it, unless they have had supervision or instructions on how to use the appliance by someone who is responsible for their safety. Under no..
3 CE Declarations of Conformity: This appliance has been designed, constructed and marketed in compliance with safety requirements of EEC Directive 2006/95/EEC (Low voltage) and requirements of EMC Directive 2004/108/EEC. This appliance has been manufactured to the strictest standards and complies with all applicable legislation, including Electrical safety (LVD) and Electromagnetic interference compatibility (EMC). Parts intended to come into contact with food conform to EEC/89/109.4 IMPORTANT INFORMATION FOR CORRECT DISPOSAL OF THE PRODUCT IN ACCORDANCE WITH EC DIRECTIVE 2002/96/EC. At th..
4 Important • Never store inﬂammable or explosive items and strong corrosive acids or alkalis in the appliance. • This is a household appliance, which is produced in accordance with the national standard. It is intended for food storage only, not for storage of blood, medicine and biological products. • To prevent risk of ﬁre, keep the appliance away from petrol or any other inﬂammable items. • To prevent risk of electromagnetic interference or other accidents, do not place a microwave oven on top of the refrigerator or use any electric appliance inside the refrigerator. • D..
5 Before First Use You must allow the fridge to settle for at least twenty four hours prior to switching the power on. It is recommended that you clean the interior of the appliance prior to ﬁrst use, using a solution of bicarbonate of soda and warm water and then thoroughly dry the interior. The fridge may have an odour to it at ﬁrst use. This will disappear as the appliance cools. Please note: The appliance will work continuously until it comes down to the correct temperature. It takes two to three hours for the fridge and freezer to reach temperatures appropriate to store food. If th..
6 Fridge Use • Never put liquids in the refrigerator uncovered. • Never put hot foods in the refrigerator. Warm food should be allowed to cool to room temperature before being put into the refrigerator. • Nothing should obstruct the air inlets in the rear wall of the refrigerator, as this will cause frost and possible condensation which will be diﬃcult to remove. • Make sure food is clean and any extra water is wiped away before putting into the fridge. • Wrap or cover food before putting into the fridge. This will help prevent the loss of moisture, keep food fresh and avoid unp..
7 Freezer Use • The freezer compartments are designed to store only frozen food. • Never put hot or warm foods in the freezer, allow them to cool fully before putting them into the freezer. • Follow the instructions on the food packaging for storage of frozen food. If no information is provided, foods should not be stored for more than three months after the purchase date. • Store food in small packages (ideally less than 2.5kg). This reduces the freezing time and improves the quality of the food after thawing. • Wrap food before putting into the freezer. To stop the wrapping stic..
8 Control Panel A: Fridge temperature display B: Freezer temperature display C: Super cool light D: Holiday light E: Fridge key F: Freezer key G: Holiday key H: Super freeze light J: Alarm light K: Super cool key L: Super freeze key M: Alarm key Fig. 1 B A G F E D C L K J H M
9 Setting the Fridge Temperature The fridge temperature may be set between 2°C and 8°C. • Touch the “Fridge” key several times, until the required temperature for the fridge compartment ﬂashes in the “Fridge temperature” display. • When the display stops ﬂashing this temperature will be set. Setting the Freezer Temperature The freezer temperature may be set between -24°C and -14°C. • Touch the “Freezer” key several times, until the required temperature for the freezer compartment ﬂashes in the “Freezer temperature” display. • When the display stops ﬂashin..
10 To switch the super cool function oﬀ Either: Touch the “Super cool” OR “Fridge” key once. Or: The “Super cool” function automatically switches oﬀ after 6 hours. In either case, the fridge temperature reverts back to the setting before “Super cool” was switched on. Super Freeze Function The “Super freeze” function can be used to freeze large quantities of fresh food as quickly as possible. For best results, switch the “Super freeze” function on 12 hours prior to introducing large quantities of food to be frozen. • When this is switched on the freezer temperat..
11 In either case, the freezer temperature reverts back to the setting before “Super freeze” was switched on. Ice Cube Maker To make ice cubes using the integral ice cube maker • Slide the ice cube maker from its location in the freezer and ﬁll it with water (up to the maximum marks). • Replace the ice cube maker into position in the freezer. • Leave for at least 3 hours for the water to freeze. • Twist each of the front knobs clockwise to allow ice cubes to drop into the tray below. Holiday Mode This appliance is equipped with a holiday mode, which switches the fridge to 15°..
12 Door Open Alarm This appliance is equipped with an alarm to alert you if a door is left open. In the event that a door is left open for more than two minutes the appliance will give three beeps once a minute, for ten minutes and the “ALARM” light will illuminate; this continues until both doors are properly shut, or until the “Alarm” key is touched. Defrosting the Fridge The fridge is cooled by convection using cold air forced through channels at the rear of the fridge. No defrosting is required. Defrosting the Freezer The freezer is frost free and as such is designed not to requ..
13 Care and Cleaning Always disconnect the appliance from the power supply before any cleaning or maintenance. The fridge sections should be cleaned using a solution of bicarbonate of soda and lukewarm water. Do not use abrasive products or detergents. After washing, rinse and dry thoroughly. Clean the shelves and balconies separately by hand with soap and water. Do not put them in the dishwasher. Once cleaning is complete, then reconnect the power. Keep the door gaskets clean. If damaged, the gaskets should be replaced. If the appliance is not used for prolonged periods of time, unplug and..
14 Troubleshooting If you have any problems with your appliance, you should check the troubleshooting prior to calling CDA Customer Care to prevent unnecessary service calls and potential cost. The appliance is not working Check: • There is power to the appliance. • The house fuses are intact and the fuse in the plug has not blown. • The fridge is not in “Holiday” mode (“Holiday” light should not be illuminated on the control panel). • The plug socket is functioning correctly. To check this, plug another electrical appliance in to see if the socket is working. • The temper..
15 Note: The cooling gas in the refrigerator will make a slight bubbling noise, even when the compressor is not running. The freezer gives ten long beeps at minute intervals and/or the “Alarm” light illuminates, freezer temperature display shows “-” The most likely cause is that the freezer is too warm. • Touching the “Alarm” key for 3 seconds will display the highest temperature the freezer has reached. • To cancel the alarm, touch the “Alarm” key brieﬂy. • If a large quantity of food has only recently been added to the freezer, it is likely that the temperature wil..
16 Electrical Information Warning! This appliance must be earthed. The mains lead of this appliance has been ﬁtted with a BS 1363A 13 Amp fused plug. To change a fuse in this type of plug, follow the steps below: 1. Remove the fuse cover and fuse. 2. Fit replacement 13A fuse, ASTA approved to BS 1362 type, into the fuse cover. 3. Replace fuse cover. Important: Do not use the appliance without the fuse cover in position. How to connect an alternative plug If the ﬁtted plug is not suitable for your socket outlet, then it should be cut oﬀ and disposed of safely to prevent the risk of ele..
17 As the colours of the wires in the mains lead of this appliance may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows:- • The wire which is coloured GREEN and YELLOW must be connected to the terminal which is marked with letter (E) or by the Earth symbol or coloured GREEN and YELLOW. • The wire which is coloured BLUE must be connected to the terminal which is marked with the letter (N) or coloured BLACK. • The wire which is coloured BROWN must be connected to the terminal which is marked with the letter (L) or coloured RED. If in d..
19 NOTES E & O E. All instructions, dimensions and illustrations are provided for guidance only. CDA reserve the right to change speciﬁcations without prior notice.
www.cda.eu Please contact our Customer Care Department for Service on the details below Customer Care Department The Group Ltd. • Harby Road • Langar • Nottinghamshire • NG13 9HY T : 01949 862 012 F : 01949 862 003 E : [email protected] Copyright © CDA 2015
Copyright © 2014 - 2020 Download User Manuals