Electric Dryer - Maytag MEDX6STBW Manual

Electric Dryer - Maytag MEDX6STBW Manual

Sponsored Links

Dimension Guide Manual Summary


Search in this Manual:

PRODUCT MODEL NUMBERS - Page 1

Electric Dryer PRODUCT MODEL NUMBERS W10646601A 12/2014 MEDX6STB 29" (737 mm) 43 3 / 8 " (1102 mm) 1 / 2 " (13 mm) NOTE: Leveling legs should be 1/2" (13 mm) (to match height of 3.6 cu. ft. capacity washer) or 1½" (38 mm) (to match height of 3.8 cu. ft. capacity washer). The location must be large enough to allow the dryer door to open fully. Front View A B 22 3 / 4 " (578 mm) 27 3 / 4 " (705 mm) 27 3 / 4 " (705 mm) 13 3 / 4 " (349 mm) Side View A. Wide opening side-swing door B. Wide opening hamper door *Most installations require a minimum 5½" (140 mm) clearance behind the dryer for the..

ELECTRICAL REQUIREMENTS - Page 2

Because Whirlpool Corporation policy includes a continuous commitment to improve Dimensions are for planning purposes only. For complete details, see Installation our products, we reserve the right to change materials and specifications without notice. Instructions packed with product. Specifications subject to change without notice. To supply the required 3 or 4 wire, single phase, 120/240 volt, 60 Hz., AC only electrical supply (or 3 or 4 wire, 120/208 volt electrical supply, if specified on the serial/rating plate) on a separate 30-amp circuit, fused on both sides of the line. A time-..

Electric Dryer
PRODUCT MODEL NUMBERS
W10646601A
12/2014
MEDX6STB
29"
(737 mm)
43
3
/
8
"
(1102 mm)
1
/
2
"
(13 mm)
NOTE:
Leveling legs should be 1/2" (13 mm) (to match
height of 3.6 cu. ft. capacity washer) or 1½" (38 mm) (to
match height of 3.8 cu. ft. capacity washer). The location
must be large enough to allow the dryer door to open fully.
Front View
A
B
22
3
/
4
"
(578 mm)
27
3
/
4
"
(705 mm)
27
3
/
4
"
(705 mm)
13
3
/
4
"
(349 mm)
Side View
A. Wide opening side-swing door
B. Wide opening hamper door
*Most installations require a minimum 5½" (140 mm) clearance
behind the dryer for the exhaust vent with elbow. See “Venting
Requirements.”
Back View
30
1
/
4
"
(768 mm)
14
1
/
2
"
(368 mm)
4
3
/
4
"
(121 mm)
4"
(101 mm)
14
1
/
2
"
(368 mm)
4
3
/
4
"
(121 mm)
Steam
Non-Steam
Minimum spacing for recessed area or closet installation
The dimensions shown following are for the minimum spacing allowed.
Additional spacing should be considered for ease of installation
and servicing.
Additional clearances might be required for wall, door, and floor
moldings.
Additional spacing of 1" (25 mm) on all sides of the dryer
is recommended to reduce noise transfer.
For closet installation, with a door, minimum ventilation openings in
the top and bottom of the door are required. Louvered doors with
equivalent ventilation openings are acceptable.
Companion appliance spacing should also be considered.
Minimum Required Spacing
3"*
(76 mm)
3"*
(76 mm)
24 in.
2
*
(155 cm
2
)
48 in.
2
*
(310 cm
2
)
18"*
(457 mm)
1"*
(25 mm)
1"*
(25 mm)
5
1
/
2
"*
(140 mm)
14"* max.
(356 mm)
A. Recessed area
B. Side view - closet or confined area
C. Closet door with vents
*Required spacing


Related Models

There are Total 3 Manuals For MEDX6STBW.